Find Parts

Search By Item Number Or Keyword
Search Manufacturers By Letter

Still Can't Find It?

If you're unable to locate an item please contact us directly.

Please have the following information ready:

  1. Firearm Manufacturer
  2. Firearm Model and Serial Number
  3. Gauge or Caliber of Firearm
  4. Part Description
  5. Any other pertinent information

Then please call our Sales Department toll free at:

866-NUMRICH

(866-686-7424)

Outside U.S.A.

845-679-2417

Office Hours:

Monday through Friday
8:00 a.m. to 4:30 p.m. EST

Forums

Forums Home > Shotguns > J.C. Higgins Model 101.25 shotgun
J.C. Higgins Model 101.25 shotgun
Replies for J.C. Higgins Model 101.25 shotgun
Author Message
Allen560971
Author Image
Joined: January 1900
Posts: 1
Location:
EUSTIS, FL
Posted: April 20, 2013 6:01 PM

Hi ,

I have a problem with the magazine tube falling out when there are no shells in the gun, it seems as though there is no spring tension to hold it in can anyone help?

Thanks,
Ed  
Zeke
Author Image
Joined: August 2011
Posts: 4153
Location:
JAMESPORT, NY
Posted: April 21, 2013 10:22 AM
I'm not sure what you mean by falling out...is it pulling free of the reciever block? (part #39-51..dovetail block,front)  If it is, then the way the tube is secured is by the formost barrel band,,,the -45 in our hosts schematic..take note thast there is a cross screw(39-164 magazine yoke tube screw)  this tension the outer tube...the inside tube has a extebded pin thru the magazine plug(39-149) that engages the trackway in the magazine tube collar....if this trackway is worn or misshappen fromm years of use, then it will allow the inner magazine tube to rotate and drop out. You can add a "detent" of sorts by taking note of the pin position when the inner tube is rotated into place. You add the detent feature by using a sharp,pointed prick punch to peen a little dimple of metal into the pathway to restrict the tube rotation..It doesn't have to be a lot of metal....just enough to make a "SNAP" noise  when the rotation is turned into place..OTHERS:  The slot may be spread or the pin worn...check both...the pin may require replacement and you may have to reduce the width of the trackway with a bit of a pinch with a pair of pliers  Make sure that the inside mag tube and its follower ar installed properly..if the follower has been inverted..then all tension is lost when empty
Zeke
Author Image
Joined: August 2011
Posts: 4153
Location:
JAMESPORT, NY
Posted: April 21, 2013 10:24 AM
BTW  The gun is made by Stevens and their factory model(s) are the 39A and 59 A...use that schematic and parts list...you can also replace the parts I cited;;;;;
Allen560971
Author Image
Joined: January 1900
Posts: 1
Location:
EUSTIS, FL
Posted: April 21, 2013 9:02 PM
Thanks Zeke, for the help, it is the inner magazine tube that is falling out, the spring loaded one that pushes the shells, I will try your suggestions and see what happens Thanks again.

Ed Greenwell
Our members have made a total of 240002 posts
We have 517262 registered members
The newest member is Kale1032973
FORUM RULES
You are not logged in.
You cannot post replies