Notifications

Close
Forum > Gunsmithing > Gunsmithing > Remington Model 1900 help

Remington Model 1900 help

Author Message
Randy601904
Joined: October 2010
Posts: 0
Posted: November 4, 2022 11:12 AM

I have a model 1900 in the shop for restoration. I have the receiver fully stripped except for the firing pin cups. They will not come out. I am looking for any reasonable suggestion for the removal of these cups. HELP!!!

Delos579621
Joined: September 2011
Posts: 235
Posted: November 4, 2022 01:22 PM

The firing pins are held in by threaded plugs with screw driver slots.You need a 1/4" screw  driver bit exactly the size of the slots in the plugs and 1/4" or 3/8" ratchet.You will need penetrating spray and allow it to  set for a while then spray again.Most of the time it takes a while to get them out.