Notifications

Close
Forum > Gunsmithing > Gunsmithing > Revelation model 350a trigger spring install

Revelation model 350a trigger spring install

Author Message
locomike65
Joined: September 2022
Posts: 0
Posted: September 21, 2022 10:17 AM

HI, I inherited my dads old shotgun, single shot 12ga,  had a trigger issue i took it apart and saw that the trigger spring was broken. I found one here and bought it also the diagram was very helpful but the spring broke on re assembly.

It was really difficult to  put back together, if anyone knows any tricks to make this easier please share.

Finally I used a broken toothpick to hold the spring and trigger together while inserting into the recieved and drove it out with the pin.

Not sure if the spring broke on re assembly  or its just cheap junk, seemed kinda flimsy for what it needs to do.

Any help or advice please?