Liberty 21

Author Message
daniel
Joined: January 1900
Posts: 179
Posted: September 2, 2012 01:28 PM
test
daniel
Joined: January 1900
Posts: 179
Posted: September 2, 2012 01:35 PM

RJ

Have in a Liberty 21 made in Germany. .22 LR 7 shot DA with 2 3/8" barrel searial #115**.

Need a center pin and hammer.

Also have in a Baby Hammerless Model 1921.

Need the main spring

daniel

Pul7gs
Joined: January 1900
Posts: 345
Posted: September 2, 2012 07:44 PM

There is a Liberty 21 parts gun now on Gunbroker.com

Pul7gs
Joined: January 1900
Posts: 345
Posted: September 2, 2012 08:11 PM

General Pershing’s troops found out during the Spanish American war in the Philippines that even a 38 special could not stop the Moro Gorillas hopped up on adrenaline and other things. He resorted to the 1911 45 auto to do the job. What do you think a 22 short will do to the same bad guy coming at you to do you harm? Just p**s him off.

daniel
Joined: January 1900
Posts: 179
Posted: September 4, 2012 05:11 PM

RJ

The center pin hole through the cylinder is 0.128". The pin would need to be a minimun of 1.75"

The hammer is double action with a hammer nose and an internal hex head screw as its pivot, the trigger is also pivoted by a hex head screw.The hammer for the small frame HS 21 would not work.

The hand pivots off the trigger and is sprung with a coil spring

This pistol has a left side plate held on by a single screw at the rear covered by the grips.

daniel

daniel
Joined: January 1900
Posts: 179
Posted: September 5, 2012 11:15 AM

RJ

The Clerke M21 is right on as far as what the picture shows.

daniel

daniel
Joined: January 1900
Posts: 179
Posted: September 6, 2012 11:20 AM

RJ

guy6841@comcast.net

daniel

daniel
Joined: January 1900
Posts: 179
Posted: September 11, 2012 01:19 PM

RJ

Have placed order for part # 1407680A. I need the hammer with the wider nose as shown in the e-mail sent.

order # 2362234

daniel

daniel
Joined: January 1900
Posts: 179
Posted: September 17, 2012 11:35 AM

RJ

Received hammer. Do you have hammer in blue, also will need to change rebound lever.

The bottom of thr hammer in the Liberty 21 is 0.509" from the front of the nose at the single action notch to the rear at the rebound point on the hammer.

daniel

daniel
Joined: January 1900
Posts: 179
Posted: September 20, 2012 06:13 AM

RJ

Received ejector pin, fits like it will work.

daniel