Notifications

Close

Please note: for the health and safety of our employees, we are operating with limited staff and it may take up to 3 weeks to fulfill your order.

At this time, we no longer accept orders over the phone.

Forum > Rifles > Rifles > Ted Williams Model 200 rear brass bead sight

Ted Williams Model 200 rear brass bead sight

Author Message
Dave999999
Joined: February 2015
Posts: 0
Posted: April 14, 2018 08:51 PM

i am looking for a replacement brass rear bead sight (vent rib) for a Ted Williams Model 200.  

The dimensions of the bead sight and depth of threads will also be helpful.  Thank you in advance!

Ezequiel
Joined: August 2011
Posts: 7448
Posted: April 15, 2018 09:03 AM (This post was last edited December 21, 2018 09:41 AM)

The gun was made by High Standard and uses their parts..however the beads are generic...if our host doesn't have one Check with the Tech Staff at www.brownells.com on a replacement.   threads_: 2 sizes are generally used   3/56 or 6/48 and are made in brass or silver coloted   with bead choices of  .067......130 or .170 rib mounted shotgun beads are used with the small mounted mid rib and the larger   one at the muzzle.......removal can be an issue as some are installed with a thread locker liquid   The use of an electric soldering iron...the tip applied directly to the bead to soften a thread locker compound,,,,, Brownelss also offer directions..tools and tutorials on the process of removal and replacement,,,,,,,they also have taps to chase the threads with

 

 

 

GunPartsCorp
Joined: August 2017
Posts: 5782
Posted: April 19, 2020 09:08 AM

 

Regarding your inquiry concerning the Ted Williams 200 front sight bead (a/k/a Winchester 1200).  Please see attached parts list of available parts.  The standard front sight beads are typically 3x56 TPI. 

 (https://www.gunpartscorp.com/gun-manufacturer/winchester/shotguns-win/1200/parts-list-win1200)

 

Regards,

Numrich Gun Parts Corporation

GunPartsCorp
Joined: August 2017
Posts: 5782
Posted: April 20, 2020 08:58 AM

 

Many shotguns with a vent rib use a front sight bead near the muzzle end of the barrel and a middle bead approx. midway down the rib.  Middle beads are smaller in diameter and use a smaller thread size, typically 2x56 TPI.   Depth information is not available.   We assume that when you are referring to a rear bead it is actually the middle bead you need.  

Regards,

Numrich Gun Parts Corporation

GunPartsCorp
Joined: August 2017
Posts: 5782
Posted: April 21, 2020 08:20 AM

 

Besides 2 x 56 TPI, some middle beads are 2x44 TPI also.

Regards,

Numrich Gun Parts Corporation